point-to-point: Configure the type of the subinterface as point-to-point.
Description
Using the interface mfr command, you can configure a MFR bundle interface or enter
the view of the MFR bundle interface. Using the undo interface mfr command, you
can cancel the designated MFR bundle interface.
By default, no MFR bundle interface is created.
In bundle subinterface configuration, if the multipoint or point-to-point parameter are
not designated, the default type is multipoint.
The MFR interface is a virtual interface, which could be bundled with multiple physical
interfaces to be aggregated into a single MFR interface with more bandwidth.
The undo interface mfr command will work only if all physical interfaces have been
removed from the MFR interface.
The subinterface of a MFR interface cannot be created until the main MFR interface is
created.
For related commands, see link-protocol fr mfr, mfr bundle-name.
Example
# Create a MFR bundle interface and a subinterface of the main interface.
[3Com]interface mfr 0
[3Com-MFR0]interface mfr0.1 point-to-point
6.1.48 link-protocol fr
Syntax
link-protocol fr [ ietf | nonstandard ]
View
Interface view
Parameter
ietf: IETF standard datagram format.
nonstandard: Nonstandard datagram format.
Description
Using the link-protocol fr command, you can configure the link layer protocol of the
interface to Frame Relay.
Default link layer protocol of the interface is PPP. Default Frame Relay protocol
datagram format is IETF.
For related commands, see display interfaces.
Link Layer Protocol
129
Need help?
Do you have a question about the 3C13618 and is the answer not in the manual?