Ipx Enable - 3Com 3C13618 Command Reference Manual

Parameter
None
Description
Using the ipx default-route command, you can enable the IPX default route. Using
the undo ipx default-route command, you can disable the IPX default route.
By default, this function is enabled.
In Quidway series router, you can configure IPX default route to forward those
packets for which no route has been found.
Example
# Disable the default route.
[Quidway] undo ipx default-route

5.1.7 ipx enable

Syntax
ipx enable [ node node ]
undo ipx enable
View
System view
Parameter
node: Route node ID, 48 bits in length. 3 groups of 4 bit hexadecimal separated by ".",
e.g. (xxxx.xxxx.xxxx). It cannot be a broadcast address. The default is MAC address
of the first Ethernet interface of the route.
Description
Using the ipx enable command, you can enable IPX Routing. Using the undo ipx
enable command, you can disable IPX Routing.
By default, IPX Routing is disabled.
When the MAC addresses change, if you omit the node value, the node values of
routers will automatically change. In this way, the communication may break off
during the period when the MAC addresses are changing and the clients and servers
are getting new addresses.
Network Protocol
79