Firewall - 3Com 3C13618 Command Reference Manual

3Com Command Reference Guide — V1.00
Example
# Display the information about timerange packet filtering.
[3Com]display timerange
TimeRange packet-filtering enable.
beginning of time range:
01:00 - 02:00
03:00 - 04:00
end of time range.

3.1.7 firewall

Syntax
firewall { enable | disable }
View
System view
Parameter
enable: Enabling the firewall.
disable: Disabling the firewall.
Description
Using the firewall command, you can enable or disable the firewall.
By default, Firewall is enabled.
This command is used to enable or disable the firewall, and the corresponding result
can be displayed via the display firewall command. If time-based packet filtering is
adopted, then this command is shut down when the firewall is shut down. This
command controls the general switch of the firewall. When the firewall disable
command is used to close the firewall, the statistics of the firewall will be deleted at
the same time.
For related commands, see acl, firewall packet-filter.
Example
# Enable the firewall.
[3Com]firewall enable
34