Vlink - 3Com 3C13618 Command Reference Manual

3Com Router Command Reference Guide — V1.00
undo stub cost cost area area-id [ no-summary ]
View
OSPF view
Parameter
area_id: Area ID of the stub area.
cost: The cost of the default route of the stub area
no-summary: Configure an area as Totally Stubby area when using this option.
Description
Using the stub area command, you can configure an area as "stub area" or "Totally
Stubby area". Using the undo stub area command, you can cancel the designated
stub area or Totally Stubby area.
By default, the system configures no stub area or Totally Stubby area.
Example
# Specify area 2 as the stub area with the cost as 2.
[3Com-ospf] stub cost 2 area 2
# Specify area 1 as totally stubby area with the cost as 1.
[3Com-ospf] stub cost 1 area 1 no-summary

3.1.38 vlink

Syntax
vlink peer-id router-id transit-area area-id [ hello-timer seconds ] [ retransmit-timer
seconds ] [ transit-delay seconds ] [ dead-timer seconds ]
undo vlink peer-id router-id transit-area area-id
View
OSPF view
Parameter
router_id: The IP address of the virtual connection neighbor, in dotted decimal format.
area_id: ID of the virtual link transmission area
66