Controller T3 - 3Com 3C13618 Command Reference Manual

Parameter
master: Uses the internal clock.
slave: Uses the line clock.
Description
Using the clock command, you can configure a clock mode for the CT3 interface.
Using the undo clock command, you can restore the default clock mode of the CT3
interface.
By default, the clock mode is slave.
The clock mode is selected depending on the connected remote device. If it is a
transmission device, the local end will use the line clock.
If the CT3 ports of the two routers are directly connected, one router should use the
internal clock whereas the other router uses the line clock.
Example
# Configure CT3 interface with internal clock.
[3Com-T3-0]clock master

3.7.3 controller t3

Syntax
controller t3 interface-number
View
System view
Parameter
interface-number: Number of CT3 interface.
Description
Using the controller t3 command, you can enter the CT3 interface view.
For related commands, see display controller t3.
Example
# Enter the CT3 interface view.
Interface Management
71