Isdn Protocol-Type - 3Com 3C13618 Command Reference Manual

Parameter
None
Description
Using the isdn overlap-receiving command, you can configure an ISDN PRI interface
to receive dialed numbers in overlap-receiving mode. Using the undo isdn
overlap-receiving command, you can configure the ISDN PRI interface to receive
dialed numbers in complete receiving mode,.
By default, overlap-receiving mode is adopted.
If a calling party sends the called numbers in "overlap-sending" mode, the receiving
mode on the interface must be set to "overlap-receiving". If the calling party sends the
called numbers in "complete sending" mode, the receiving mode on the interface can
be set to either "complete receiving" or "overlap-receiving".
This command cannot take effect unless the ISDN PRI interface adopts QSIG
signaling.
For related commands, see isdn sending-complete, isdn protocol-type.
Example
# Set the interface Serial2:15 to receive called numbers in complete receiving mode.
[3Com-Serial2:15]undo isdn overlap-receiving

4.1.10 isdn protocol-type

Syntax
isdn protocol-type { dss1 | qsig }
View
System view
Interface view
Parameter
dss1: DSS1 (Digital Subscriber Signaling No.1) signaling is used.
qsig: QSIG signaling is used.
Description
Using the isdn protocol-type command, you can configure signaling to be used at the
ISDN PRI interface.
By default, DSS1 signaling is adopted.
Link Layer Protocol
37