X25 Reverse-Charge-Accept; X25 Roa-List - 3Com 3C13618 Command Reference Manual

5.1.36 x25 reverse-charge-accept

Syntax
x25 reverse-charge-accept
undo x25 reverse-charge-accept
View
Interface view
Parameter
None
Description
Using the x25 reverse-charge-accept command, you can configure an X.25 interface
to accept the call which includes facility "reverse charging request". Using the undo
x25 reverse-charge-accept command, you can prohibit the interface form accpeting
the call which includes facility "reverse charging request".
By default, the function of reverse-charge call acceptance is disabled on an X.25
interface.
This function does not affect any call without the reverse charge call function
On an X.25 interface, you can enable the function of reverse-charge call. Then, any
such calls to this X.25 interface will be accepted. If the option of accept-reverse in the
x25 map command enables the function for a mapping, only the calls with related
mapping to this interface could be accepted while the other calls (i.e., the calls carrying
the request of reverse charge, but with no related mapping) will be cleared.
For related commands, see x25 map.
Example
# Set acceptance of reverse charge calls function on interface Serial2.
[3Com-Serial2]x25 reverse-charge-accept

5.1.37 x25 roa-list

Syntax
x25 roa-list roa-name id1 [ ,id2, id3...]
undo x25 roa-list name id1 [ ,id2,id3...]
View
System view
Link Layer Protocol
73