Dialer-Group - 3Com 3C13618 Command Reference Manual

View
Dialer interface view
Parameter
username: Remote user name for PPP authentication, which is a string of 1 to 31
characters.
Description
Using the dialer user command, you can configure remote user names for
authenticating the requests when calls are received. Using the undo dialer user
command, you can cancel the remote user names.
By default, no remote user name is set.
This command is only valid on dialer interfaces of Resource-Shared DCC.
When dialer interfaces run link protocol of PPP, the remote user names, which are
obtained via PPP authentication and configured with dialer user respectively, will
decide which dialer interface will receive the incoming call.
When dialer interfaces run link protocol of Frame Relay, the calling numbers, which
are received from incoming call and configured with dialer number respectively, will
decide which dialer interface will receive the incoming call. In this case, dialer
number must be configured, and dialer user can be configured optionally.
For related commands, see ppp pap local-user, ppp chap user.
Example
# Set the remote username to "RouterB".
[3Com-Dialer3] dialer user RouterB

1.1.20 dialer-group

Syntax
dialer-group group-number
undo dialer-group
View
Physical or dialer interface view
Dial-Up
19