X25 Switch Svc Xot - 3Com 3C13618 Command Reference Manual

sub-source source-address: substitute source address.
Description
Using the x25 switch svc interface command, you can add an X.25 switching route
with the forwarding address (or Annex G DLCI) as this interface. Using the undo x25
switch svc interface command, you can cancel the specified X.25 switching route.
By default, no X.25 switching route is configured.
Configuring with X.25 switching, 3Com series Routers can be used as X.25 switches.
The output interface for SVC switching can be either an X.25 interface or an Annex G
DLCI. Before configuring SVC switching, the output interface should have been
configured with X.25 or Frame Relay and have been configured with the outgoing
Annex G DLCI.
Before utilizing this command, the X.25 switching must be enabled with x25 switching
command.
For related commands, see x25 switch svc xot, display x25 switch-vc-table svc,
x25 switching.
Example
# Switch the VC (Virtual Circuit) destined to the address 1 to the interface Serial 0, and
the VC destined to the address 2 to Serial 1.
[3Com]interface serial 0
[3Com-Serial0]link-protocol x25 dce ietf
[3Com]interface serial 1
[3Com-Serial1]link-protocol x25 dce ietf
[3Com]x25 switch svc 1 channel interface serial 0
[3Com]x25 switch svc 2 channel interface serial 1
# Switch the VC destined to the address 3 to Annex G DLCI.
[3Com-Serial0]link-protocol frame-relay
[3Com-Serial0]frame dlci 100
[3Com-fr-dlci-100]annexg dce
[3Com]x25 switch svc 3 interface serial 0 dlci 100

5.1.40 x25 switch svc xot

Syntax
x25 switch svc x.121-address [ sub-dest destination-address ] [ sub-source
source-address ] xot ip-address1 [ ip-address2 ] ... [ ip-address6 ] [ xot-option ]
undo x25 switch svc x.121-address [ sub-dest destination-address ] [ sub-source
source-address ] [ xot ip-address1 [ ip-address2 ] ... [ ip-address6 ] ] [ xot-option ]
Link Layer Protocol
77