5.1.5 display x25 hunt-group-info
Syntax
display x25 hunt-group-info [ hunt-group-name ]
View
All views
Parameter
hunt-group-name: the name of the hunt group
Description
Using the display x25 hunt-group-info command, you can view the status information
of X.25 hunt group.
By default, display the status information of all the hunt groups.
For related commands, see x25 hunt-group.
Example
# Display the status information on X.25 hunt group hg1.
[3Com]display x25 hunt-group-info hg1
HG_ID
HG_Type
===================================================================
hg1
round-robin
===================================================================
Table 5-1 Meaning of each field in the display x25 hunt-group-info command
Field
HG_ID
HG_Type
HG_Target
HG_uses
HG_status
HG_traffic(out/in)
HG_Target
HG_uses
Serial0
2
Serial1
1
1.1.1.1
1
Name of the hunt group
Selection policy for calling channel of hunt group, including round-robin and
vc-number
Interfaces or XOT tunnels included in the hunt group
Number of calls made on the interface or XOT tunnel (including successful calls or
failed calls)
Status of the active interface or XOT tunnel, including:
Last used: used the last time
Next: the interface or XOT tunnel selected by round-robin selection policy next time
Normal: in normal status
Input/output traffic via the interface or XOT tunnel in packets
HG_status
HG_traffic(out/in)
Last used
51/20
Next
21/15
Normal
24/3
Meaning
Link Layer Protocol
45
Need help?
Do you have a question about the 3C13618 and is the answer not in the manual?