2.1.14 rip authentication-mode md5 key-string
Syntax
rip authentication-mode md5 key-string string
undo rip authentication-mode
View
Interface view
Parameter
string: Key string of MD5 algorithm specified on an interface.
Description
Using the rip authentication-mode md5 key-string command you can configure
RIP-2 authentication in the md5 encryption mode. Using the undo rip
authentication-mode command, you can cancel the authentication performed on
RIP-2.
By default, the interface does not authenticate packets.
RIP does not support authentication, while RIP-2 supports. RIP-2 has two authentication
modes: plaintext authentication and MD5 authentication.
authentication and MD5 authentication
Example
# Set MD5 authentication at Serial0, and the key string is aaa
[3Com-Serial0] rip version 2
[3Com-Serial0] rip authentication-mode md5 key-string aaa
2.1.15 rip authentication-mode md5 type
Syntax
rip authentication-mode md5 type [ nonstandard-compatible | usual ]
undo rip authentication-mode
View
Interface view
Routing Protocol
RIP-2 mainly consists of simple
25
Need help?
Do you have a question about the 3C13618 and is the answer not in the manual?