Nat Address-Group - 3Com 3C13618 Command Reference Manual

This command displays the configuration of the address translation by the user. The
user can verify if the configuration of the address translation is correct according to
the input information of this command.
Example
# Display the NAT Translations items information.
[Quidway] display nat translations

2.6.4 nat address-group

Syntax
nat address-group start-addr end-addr pool-name
undo nat address-group pool-name
View
System view
Parameter
start-addr: The starting address of the NAT address pool.
end-addr: The ending address of the NAT address pool.
pool-name: Name of the pool.
Description
Using the nat address-group command, you can configure a NAT address pool.
Using the undo nat address-group command, you can cancel a specified NAT
address pool.
All addresses in the address pool should be consecutive. At the most, 64 addresses
can be defined in each address pool.
An address pool can't be deleted once it is correlated to one access control list and
address translation has started.
Example
# Configure one address pool from 202.110.10.10 to 202.110.10.15, with the name
pool1.
[Quidway] nat address-group 202.110.10.10 202.110.10.15 pool1
Network Protocol
43