Ipx Sap Timer Update - 3Com 3C13618 Command Reference Manual

Description
Using the ipx sap multiplier command, you can configure the SAP service
information table aging period. Using the undo ipx sap multiplier command, you
can restore the default aging period.
Information on SAP will be regarded as invalid after a period of no updating. It is
recommended that the SAP aging periods set on the routers in the same network
should be the same.
For related commands, see ipx sap timer update.
Example
# If the SAP update interval is 2 minutes, then the SAP aging multiplier is 10 minutes
after the following command is executed.
[Quidway] ipx sap multiplier 5

5.1.22 ipx sap timer update

Syntax
ipx sap timer update seconds
undo ipx sap timer update
View
System view
Parameter
seconds: Used to calculate the SAP update time, ranging from 60 to 60000 seconds.
The default value is 60 seconds.
Description
Using the ipx sap timer update command, you can configure intervals for IPX SAP
to control how long it will be waiting to receive the next SAP update packets. Using
the undo ipx sap timer update command, you can restore the default value.
When a router is started or shut down, it needs to exchange information with other
routers through propagation. When it is running, it needs to propagate outward
cyclically to exchange information with other servers. The ipx sap timer update
command is used to set the time interval between two rounds of service information
propagation. This interval is 60 seconds by default. In the same network segment,
this interval should be of the same value.
Network Protocol
91