Pos-Server Map - 3Com 3C13618 Command Reference Manual

3Com Router Command Reference Guide — V1.00
Example
# Modify answertime to 800 milliseconds, tradetime to 20 minutes (1200000
milliseconds), and packetinterval to 6 seconds (6000 milliseconds).
[3Com] pos-server fcm answertime 800 tradetime 1200000 packetinterval 6000

5.1.12 pos-server map

Syntax
pos-server map { des-code | default } app-number
undo pos-server map { des-code | default }
View
System view.
Parameter
des-code: Number identifying the destination application in the POS packet,
composed of four hexadecimal numbers (e.g., FFFF). The service center distributes
this code number for POS access devices when performing network planning.
default: Default POS mapping.
app-number: POS application number, ranging from 0 to 31.
Description
Using the pos-server map command, you can configure the multi-application POS
mapping table. Using the undo pos-server map command, you can cancel the
mapping table.
By default, no multi-application POS mapping table is configured.
POS multi-application is a kind of POS access function which sends the packets from
a POS terminal to different POS applications according to the destination addresses
packed. For the TCP/IP connection, an application is marked by two parts, IP address
and port number, that is, different applications may have different IP addresses or
share the same IP address but have different port numbers. The packets can be sent
to different applications according to the destination address numbers and the
mapping table configured. When the destination address number has a corresponding
entry in the mapping table, the packet will be sent to the application corresponding to
the entry. If there is no entry that matches the destination address, the packet will be
sent to the default application.
92