Dialer Timer Idle - 3Com 3C13618 Command Reference Manual

Parameter
seconds: Interval for originating the next call, ranges from 0 to 65535 seconds. By
default, the interval is 20 seconds.
Description
Using the dialer timer enable command, you can configure an interval for the next
call attempt on an interface after the link is disconnected. Using the undo dialer
timer enable command, you can restore the default interval.
Example
# Set the interval for DCC to make the next call attempt to 5 seconds.
[3Com-Serial0] dialer timer enable 5

1.1.17 dialer timer idle

Syntax
dialer timer idle seconds
undo dialer timer idle
View
Physical or dialer interface view
Parameter
seconds: Time that a link is allowed to be idle, ranges from 0 to 65535 seconds. By
default, seconds is 120 seconds.
Description
Using the dialer timer idle command, you can configure the interval that a link is
allowed to be idle (in other words, the interval when there is no packets which comply
with the "permit" statements transmitted) after a call has been set up on the interface.
Using the undo dialer timer idle command, you can restore the default duration.
After a link is set up, the timer idle timer will take effect. If no interesting packets are
transmitted on the link within the specified time, DCC will automatically disconnect the
link. If timer idle is set to 0, the link will never be disconnected, regardless of whether
there are no packets which comply with the "permit" statements being transmitted
over the link or not.
Dial-Up
17