Chapter 4 Isdn Configuration Commands; Isdn Configuration Commands; Debugging Isdn; Dialer Data2Voice - 3Com 3C13618 Command Reference Manual

Chapter 4 ISDN Configuration Commands

4.1 ISDN Configuration Commands

4.1.1 debugging isdn

Syntax
debugging isdn { cc | q921 | q931 | qsig { alarm | call-state | error | information |
message | all } } [ interface type number ]
View
All views
Parameter
alarm: To display alarm information.
call-state: To display calling status and timeout information of timer.
error: To display error information.
information: To display general prompt information.
message: To display description information of message.
all: To display all debugging information.
interface type number: Interface type and number. This parameter is used for
debugging ISDN signaling on a specified ISDN interface. If no interface is specified by
this parameter, ISDN signaling debugging on all the ISDN interfaces will be enabled.
Description
Using the debugging isdn command, you can enable ISDN signaling debugging.
This command is used to enable the debugging of various types of ISDN signaling and
check the status of different layers at the ISDN PRI interface on a router. You may
locate and solve the problems according to debugging information.
Example
None

4.1.2 dialer data2voice

Syntax
dialer data2voice
undo dialer data2voice
Link Layer Protocol
29