Reset Xot - 3Com 3C13618 Command Reference Manual

3Com Router Command Reference Guide — V1.00
Description
Using the link-protocol x25 command, you can configure the link layer protocol of the
interface to X.25. Later on, all the incoming or outgoing datagram will be transmitted in
X.25 mode. The interface that has executed this command is called the X.25 interface.
The default link layer protocol of the interface is PPP. For X.25, the default operation is
DTE IETF.
If X.25 switch function is disabled, when two routers are connected back-to-back using
X.25 protocol, one should be configured to work as DTE and the other as DCE; when
connecting these two routers through an X.25 public packet network, both of them
should work as DTE. If X.25 switch function is enabled, the router should work as DCE.
In a normal application without any special requirement, please select datagram
encapsulation in the IETF format.
For related commands, see display interfaces.
Example
# Specify the use of X.25 protocol on the specified Serial0, which works in DTE IETF
mode.
[3Com-Serial0]link-protocol x25 dte ietf

5.1.19 reset xot

Syntax
reset xot remote remote-ip-address remote-port local local-ip-address local-port
View
All views
Parameter
remote-ip-address: remote IP address connected via XOT
remote-port: number of remote port connected via XOT
local-ip-address: local IP address connected via XOT
local-port: number of the local port connected via XOT
Description
Using the reset xot command, you can reset a XOT link initiatively.
The port number used for clearing XOT link can be obtained through display tcp
status command.
For related commands, see display x25 vc, x25 switching, display tcp status.
56