Speed - 3Com 3C13618 Command Reference Manual

undo send-frame-type
View
Ethernet interface view
Parameter
ethernet_ii: The Ethernet_II frame type is adopted.
ethernet_snap: The Ethernet_SNAP frame type is adopted.
Description
Using the send-frame-type command, you can configure the send frame type of the
IP datagram for the Ethernet interface. Using the undo send-frame-type command,
you can restore the send frame type of IP datagram to default.
By default, the send frame type of IP datagram is Ethernet_II.
The Ethernet interface of the 3Com series of routers supports the following four frame
types:
Ethernet_II
Ethernet_SNAP
802.2
802.3
Ethernet_II and Ethernet_SNAP frame type support IP protocol, and all four types
support IPX. The Ethernet interface can auto-discriminate the types of frames
received, so it can receive packets of multiple frame types concurrently. But it can
only send packets of one single frame type at the same time.
For related commands, see mtu, display interfaces.
Example
# Set the send frame type for the Ethernet interface to Ethernet_SNAP.
[3Com-Ethernet0]send-frame-type ethernet_snap

2.1.5 speed

Syntax
speed { 10 | 100 | negotiation }
undo speed
Interface Management
15