Ip Count Outbound-Packets; Ip Count Table - 3Com 3C13618 Command Reference Manual

3Com Router Command Reference Guide — V1.00
Example
# Specify count maximum of interior to 100.
[Quidway]ip count interior-threshold 100
# Specify count maximum of interior to 512, the default value.
[Quidway]undo ip count interior-threshold

4.1.10 ip count outbound-packets

Syntax
ip count outbound-packets
undo ip count outbound-packets
View
Interface view
Parameter
None
Description
Using the ip count outbound-packets command, you can configure IP Count to
make statistics on the output packets on the current interface. Using the undo ip
count outbound-packets command, you can disable IP Count to make statistics on
the output packets on the current interface,.
By default, no statistics is made on the packets output from the interface.
The information of a packet will be retained either in Exterior-List or in Interior-List,
depending on whether the packet matches any IP Count lists.
Example
# Set IP Count to make statistics on the packets output from the interface Ethernet0.
[Quidway-Ethernet0]ip count outbound-packets

4.1.11 ip count table

Syntax
ip count table ip-address mask
undo ip count table [ ip-address mask ]
70