Sdlc Mac-Map Local - 3Com 3C13618 Command Reference Manual

Parameter
sdlc-address: The SDLC secondary station address. The length is 1 byte and it is in
hex format..
Description
Using the sdlc controller command, you can configure SDLC secondary station
address. Using the undo sdlc controller command, you can cancel the SDLC
secondary station address.
By default, no secondary SDLC station is configured.
SDLC protocol permits that several virtual circuits exist in a SDLC physics link. The
one end connects to the primary station and the other end connects to the secondary
station. You should specify the SDLC address of each virtual circuit so as to
differentiate each virtual circuit. SDLC is the unbalanced mode through sharing or
SDLC switch. One primary equipment can be connected with several secondary
equipments and the relationship is unique. However, connection can not be
established between secondary equipments. It can ensure that communication
normally operates in one group of SDLC equipment only if the addresses of the
secondary equipments are identified. The sdlc controller command is used to
specify SDLC address for virtual circuit. The address is unique in a physical interface.
The SDLC address configured on the synchronous interface is de facto the address
of the SDLC secondary station.
SDLC addresses range from 0x01 to 0xFE. The SDLC address on a router is valid for
one physical interface. That is, the SDLC addresses configured on the different
interfaces can be the same.
Example
None

6.1.29 sdlc mac-map local

Syntax
sdlc mac-map local mac-address
undo sdlc mac-map local
View
Synchronous interface view
[ sdlc-address ]
[ sdlc-address ]
Network Protocol
117