3Com 3C13618 Command Reference Manual page 435

Parameter
type: Interface type.
number: Interface number.
Description
Using the display ipx interface command, you can view information of IPX interface.
The output of this command is helpful for the user to determine if the IPX
configuration is correct and to perform IPX fault diagnosis.
Example
# Display the IPX interface Serial 0.
[Quidway] display ipx interface serial 0
Ethernet0 is up, line protocol is up
IPX address is 2.00E0.FC01.0000 [up] line-up
Delay of this IPX network, in ticks is 1
IPX type 20 propagation packet forwarding is enabled
SAP GNS processing enabled
SAP GNS round robin processing disabled
The maximum number of services reserved is 4
IPX RIP update interval is 60 seconds, aging multiples is 3
IPX SAP update interval is 60 seconds, aging multiples is 3
RIP packet maximum size is 432 bytes
SAP packet maximum size is 480 bytes
RIP packets received 0, RIP packets sent 1
SAP packets received 0, SAP packets sent 0
0 bytes received, 0 bytes sent
5.1.3 display ipx routing-table
Syntax
display ipx routing-table [network | static | default ] [ verbose ]
View
All views
Parameter
network: Destination network ID. 8 bit hexadecimal, 1~FFFFFFFD. The first "0" can
be omitted while inputting it.
Network Protocol
75