Clock (Ce1/Pri Interface) - 3Com 3C13618 Command Reference Manual

3Com Router Command Reference Guide — V1.00
When the CE1/PRI interface operates in CE1/PRI operating mode, it is physically
divided into 32 timeslots, numbered from 0 to 31.
When put into use, all the timeslots except timeslot 0 can be divided into multiple
channel sets, and each set will automatically create a Serial interface after being
bound. The logic feature of the serial interface will be the same as that of a
synchronous serial interface.
The number
interface-number:set-number. In which, number starts from the largest serial interface
number plus 1, and set-number is the number of channel-set.
Only one timeslot binding mode can be supported on one CE1/PRI interface at one
time, that is, this command and the pri-set command cannot be used simultaneously.
For related commands, see pri-set.
Example
# Bind the timeslots 1, 2, 10-15 and 18 on the CE1/PRI interface as channel-set 0.
[3Com-E1-0]channel-set 0 timeslot-list 1,2,10-15,18

3.2.2 clock (CE1/PRI Interface)

Syntax
clock { master | slave }
undo clock
View
CE1/PRI interface view
Parameter
master: Use the internal clock mode.
slave: Use the line clock mode.
Description
Using the clock command, you can configure the clock mode on the CE1/PRI
interface. Using the undo clock command, you can restore the default clock mode
on the interface.
By default, the interface uses the slave clock mode.
34
of a Serial interface is represented by serial