X25 Xot Pvc - 3Com 3C13618 Command Reference Manual

5.1.54 x25 xot pvc

Syntax
x25 xot pvc pvc-number1 ip-address interface type number pvc pvc-number2 [ timer
seconds retry times source interface-name ]
undo x25 pvc pvc-number1
View
Interface view
Parameter
pvc-number1: PVC number of the interface at this end, ranging 1 to 4095.
pvc-number2: PVC number of the peer interface, ranging 1 to 4095.
ip-address: The destination IP address connected via XOT
interface type number: Always is Serial.
seconds: Delay of the keepalive timer connected via XOT The timer sends keepalive
packets when it is overtime to detect the usability of the connection.
times: The maximum failure time of sending keepalive. Disconnect the XOT link when
the failure time exceeds times.
interface-name: The name of the interface initiating XOT connection at this end.
Description
Using the x25 pvc command, you can add a PVC route of XOT. Using the undo x25
pvc command, you can cancel the PVC route of the appointed XOT.
By default, no PVC route is added.
After the user configures the XOT switch command of X.25 PVC, he can implement the
connection between local and remote X.25 net, spanning the IP net. After configuring
keepalive, it can support the link detection of XOT.
For related commands, see display x25 vc, x25 switching.
Example
# Connect PVC1 of interface Serial0 (10.1.1.1) on the router RTA to PVC2 of 1 (10.1.1.2)
on the peer router RTB via XOT tunnel, to implement packet switching.
# Configure on router RTA
[3Com-Ethernet0]ip address 10.1.1.1 255.255.255.0
[3Com-Ethernet0]interface serial 0
[3Com-Serial0]link-protocol x25 dce ietf
[3Com-Serial0]x25 xot pvc 1 10.1.1.2 interface serial 1 pvc 2
# Configure on router RTB
Link Layer Protocol
89