Creating A Local User; Setting Attributes Of The Local User - 3Com 400 Family Configuration Manual

198 C 11: 802.1X C
HAPTER

Creating a Local User

Setting Attributes of the
Local User
ONFIGURATION
Note that, if " " is contained in the URL, you must replace it with "
?
inputting the URL in the command line.
The "Change user password" option is available only when the user passes the
authentication; otherwise, this option is in grey and unavailable.
A local user is a group of users set on NAS. The user name is the unique identifier
of a user. A user requesting network service may use local authentication only if its
corresponding local user has been added onto NAS.
Perform the following configurations in System View
Table 209 Creating/Deleting a Local User and Relevant Properties
Operation
Add local users
Delete all the local users
Delete a local user by specifying
its type
By default, there is no local user in the system.
The attributes of a local user include its password display mode, state, service type
and some other settings.
Setting the Password Display Mode
Perform the following configurations in System View.
Table 210 Setting the Password Display Mode of Local Users
Operation
Set the password display mode of
local users
Cancel the configuration of
password display mode
means that the password display mode will be the one specified by the user
auto
at the time of configuring the password (see the
for reference), and
the accessing users must be in cipher text.
Setting the Attributes of Local Users
Perform the following configurations in Local User View.
Table 211 Setting/Removing the Attributes Concerned with a Specified User
Operation
Set a password for a specified user
Remove the password set for the
specified user
Set the state of the specified user
Set a priority level for the user
Restore the default priority level
Command
local-user user_name
undo local-user all
undo local-user { user_name | all [
service-type { lan_access | ftp | telnet
| ssh | terminal } ] }
Command
local-user password-display-mode {
cipher-force | auto }
undo local-user
password-display-mode
means that the password display mode of all
cipher-force
Command
password { simple | cipher } password
undo password
state { active | block }
level level
undo level
" when
|
command in
password
Table 211