3Com 3C13618 Command Reference Manual page 831

View
Physical or dialer interface view
Parameter
dial-number: The dial number for calling a remote end.
Description
Using the dialer number command, you can configure a dial number for placing a
call to a single remote end. Using the undo dialer number command, you can cancel
the configured dial number.
By default, no dial number is set for calling the remote end.
This command is used when the dialer interface of Circular DCC serves as caller end
and the dialer originates calls to only one destination address or the default address.
This command is only valid after at least one of the following requirements is satisfied:
The dialer route command is not configured on the interface.
The next hop address that sends packets cannot find corresponding command in
dialer route command.
When dialer interfaces of Resource-Shared DCC run link protocol of PPP, the remote
user names, which are obtained via PPP authentication and configured with dialer
user respectively, will decide which dialer interface will receive the incoming call. In
this case, dialer user must be configured, and dialer number can be configured
optionally.
When dialer interfaces run link protocol of Frame Relay, the calling numbers, which
are received from the incoming call and configured with dialer number respectively,
will decide which dialer interface will receive the incoming call. In this case, dialer
number must be configured, and dialer user can be configured optionally.
Note:
1) If dialer-group command is not configured, DCC will not dial.
2) When using Resource-Shared DCC, the same dialer number can be configured on different dialer
interfaces at the calling side; but it is not the case at the called side; otherwise, the call will fail. When
using Circular DCC, the same dialer number can be configured on different dialer interfaces at the calling
side, and it is the same to the called side.
For related commands, see dialer route.
Dial-Up
11