Toyota Celica 2005 Repair Manual page 1037

DI−836
DLC3
Tc
CG
Normal Code
2 sec.
ON
OFF
Code 11 and 21
0.5 sec.
1.5 sec.
4 sec.
2.5 sec.
ON
OFF
Code 11
2005 CELICA (RM1131U)
DIAGNOSTICS
PRE−CHECK
1.
(a)
(b)
HINT:
S
F09703
S
(c)
HINT:
S
F09750
S
0.25 sec.
0.25 sec.
If 2 or more malfunctions are indicated at the same time, the
lowest numbered DTC will be displayed first.
0.5 sec.
Code 21
R01346
− ANTI−LOCK BRAKE SYSTEM WITH ELECTRONIC
BRAKE FORCE DISTRIBUTION (EBD)
DIAGNOSIS SYSTEM
Release the parking brake lever.
Check the indicator.
When the ignition switch is turned ON, check that the ABS
warning light and the BRAKE warning light come on for
approx. 3 seconds.
When the parking brake is applied or the level of the brake
fluid is low, the BRAKE warning light come on.
If the indicator check result is not normal, proceed to trou-
bleshooting for the ABS warning light circuit or BRAKE
warning light circuit (See page DI−872 or DI−875).
In the case of not using TOYOTA hand −held tester:
Check DTC.
(1) Using SST, connect terminal Tc and CG of DLC3.
SST 09843−18040
(2) Turn the ignition switch to ON.
(3) Read DTC from the ABS warning light on the com-
bination meter.
If no code appears, inspect the diagnostic circuit or ABS
warning light circuit (See page DI−877 or DI−872).
As an example, the blinking patterns for normal code and
codes 11 and 21 are shown on the left.
(4) Codes are explained in the code table on page
DI−843.
(5) After completing the check, disconnect terminal Tc
and CG, and turn off the display.
1036
DIAIJ−04