Show Crypto - Dell C9000 Series Reference Manual

Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.5(0.1)
9.4(0.0)
Usage Information The source-interface interface attribute is applicable for both the SSH client
as well as the COPY (SCP) commands. Using these attributes the client session tags an
error to the user during run time, in case there is a mismatch between this command
and the ip ssh vrf command.
Example
Dell(conf)#ip ssh source-interface tengigabitethernet 0/36
Dell(conf)#do ssh 10.10.10.2 -l admin
Dell(conf)#no ip ssh source-interface

show crypto

Display the public part of the SSH host-keys.
C9000 Series
Syntax
show crypto key mypubkey {rsa | rsa1}
Parameters
Key
mypubkey
rsa
rsa1
Defaults none
Description
Introduced on the S6000–ON.
Introduced on the Z9500.
Introduced on the S-Series and Z9000.
NOTE: Some of the parameters in this command require licensing to access. For
more information, contact your Dell Networking representative.
Enter the keyword key to display the host public key.
Enter the keyword mypubkey to display the host public key.
Enter the keyword rsa to display the host SSHv2 RSA public key.
Enter the keyword rsa1 to display the host SSHv1 RSA public
key.
NOTE:
available.
If you enable FIPS mode, this parameter is not
Security 2000