SROS Command Line Interface Reference Guide
ppp multilink
Use the ppp multilink command to enable multilink PPP (MPPP) operation. Use the no form of this
command to disable.
Syntax Description
No subcommands.
Default Values
By default, MPPP is disabled.
Functional Notes
When enabled, this interface is capable of the following:
•
Combining multiple physical links into one logical link.
•
Receiving upper layer protocol data units (PDU), fragmenting and transmitting over the physical links
based upon the physical link MTU.
•
Receiving fragments over the physical links and reassembling them into PDUs.
Usage Examples
The following example enables MPPP:
ProCurve(config)#interface ppp 1
ProCurve(config-ppp 1)#ppp multilink
5991-2114
© Copyright 2007 Hewlett-Packard Development Company, L.P.
PPP Interface Configuration Command Set
1136