Altera cyclone V Technical Reference page 2473

Hard processor system

Hide thumbs Also See for cyclone V:

Table of Contents

pwronprgdone

USB 2.0 OTG Controller

Send Feedback

GMC must be programmed only once after initializa‐

tion.Applicable only for Scatter/Gather DMA mode.

This indicates the number of packets to be serviced

for that end point before moving to the next end

point. It is only for non-periodic end points. When

Scatter/Gather DMA mode is disabled, this field

isreserved. and reads 0.

The application uses this bit to indicate that register‐

programming is completed after a wake-up from

Power Downmode.

A write to this field clears the Global OUT NAK.

A write to this field sets the Global OUT NAK.The

application uses this bit to send a NAK handshake on

all OUT endpoints. The application must Set the this

bit only after making sure that the Global OUT NAK

Effective bit in the Core Interrupt Register

GINTSTS.GOUTNakEff) is cleared.

Power-On Programming not done

Power-On Programming Done

Disable Clear Global OUT NAK

Clear Global OUT NAK

Disable Global OUT NAK

Global OUT NAK

Altera Corporation

Show Quick Links

Table of Contents