Instrument Cluster Removal; Instrument Cluster Installation - Polaris RZR XP 1000 Service Manual

Hide thumbs Also See for RZR XP 1000:
Table of Contents

Advertisement

ELECTRICAL

Instrument Cluster Removal

NOTE: Do not allow alcohol or petroleum products
to come in contact with the instrument cluster lens.
1. Disconnect the wire harness connector from the
back side of the instrument cluster.
2. Push the instrument cluster
of the dash while securely holding the dash
rubber mount
.
NOTE: Do not remove the rubber mount from
the dash panel. Only remove the rubber mount if
necessary. The bezel
and is a serviceable part.
11.12
out from the back side
and
1
is a snap-on assembly
9925724 R01 - 2014-2015 RZR XP 1000 / RZR XP4 1000 Service Manual
© Copyright 2014 Polaris Industries Inc.

Instrument Cluster Installation

1. Spray a soap and water mixture onto the outer
surface area of the instrument cluster. This will help
the instrument cluster slide into the rubber mount
more easily.
2. Be sure the rubber mount inside the dash is fully
installed and that the indexing key on the rubber
mount is lined up with the keyway in the dash.
3. Hold the dash securely and insert the instrument
cluster into the dash. Twist the instrument cluster
gently in a clockwise motion to properly seat the
instrument cluster into the rubber mount. Apply
pressure on the bezel while pressing down on the
instrument cluster.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rzr xp4 1000

Table of Contents

Save PDF