Instrument Cluster Pinouts; Instrument Cluster Removal; Instrument Cluster Installation - Polaris RANGER 500 2018 Service Manual

ELECTRICAL
6. To exit the diagnostic mode, press and hold the
MODE button or turn the ignition key OFF once the
codes are recorded.
If there is a diagnostic problem with the power steering
system, the power steering MIL will illuminate and blink
in place of the check engine MIL.

INSTRUMENT CLUSTER PINOUTS

FUNCTION
CAN High
CAN Low
Switched Power (Vdc)
Constant Power (Vdc)
Ground
High Beam
Fuel Level Sensor

INSTRUMENT CLUSTER REMOVAL

Do not allow alcohol or petroleum products to come in
contact with the instrument cluster lens.
1. Remove seat, disconnect battery and open hood to
gain access to back of instrument cluster.
2. Disconnect the wire connectors from the back side of
the instrument cluster.
11.14
NOTE
PIN
1
2
3
4
5
8
11
NOTE
3. Push the instrument cluster out from the back side of
the dash panel, while securely holding the panel and
rubber mount.
Do not remove the rubber mount from the dash panel.
Only remove the rubber mount if necessary.

INSTRUMENT CLUSTER INSTALLATION

1. Spray a soap and water mixture onto the outer
surface area of the instrument cluster. This will help
the instrument cluster slide into the rubber mount
more easily.
2. Be sure the rubber mount inside the dash panel is
fully installed and that the indexing key on the rubber
mount is lined up with the keyway in the dash panel.
3. Hold the dash panel securely and insert the
instrument cluster into the dash panel. Twist the
instrument cluster gently in a clockwise motion to
properly seat the instrument cluster. Apply pressure
on the bezel while pressing down on the instrument
cluster.
9928485 R01 - 2017-2018 RANGER 500 / 570 Service Manual
NOTE
© Copyright Polaris Industries Inc.