Download Print this page

Rear Prop Shaft Installation - Polaris RZR XP 1000 Service Manual

Hide thumbs

Advertisement

Table of Contents
4. Once the front and rear prop shafts have been
separated, slide the rear prop shaft forward to
remove it from the transmission output shaft.
5. Remove the support bearing rubber bushing by
pulling it off the rear prop shaft.
6. Remove the rear prop shaft out of the left rear of the
vehicle.
9925724 R01 - 2014-2015 RZR XP 1000 / RZR XP4 1000 Service Manual

Rear Prop Shaft Installation

1. Reverse the appropriate "Rear Prop Shaft Removal"
2. Lubricate the transmission output shaft splines with
3. Lubricate the front and rear prop shaft mid joint with
4. Slide the rear prop shaft forward from the left rear of
5. Lubricate the support bushing with light oil to ease
6. Align the front and rear prop shafts as shown below
© Copyright 2014 Polaris Industries Inc.
procedure to reinstall the rear prop shaft.
Polaris All Purpose Grease.
Polaris All Purpose Grease.
the machine just below the PVT cover. Install the rear
prop shaft on the transmission snorkel shaft.
installation and install the bushing on the rear prop
shaft bearing.
and slide them together.
NOTE: Paint marks are applied to the front and
rear
prop
shafts
to
Reference these marks during installation if still
visible.
FINAL DRIVE
aid
shaft
alignment.
7.25
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rzr xp4 1000