Crankshaft Removal / Inspection - Polaris RZR XP 1000 Service Manual

5. Measure each bearing journal in two locations, 90
degrees apart. Replace balance shaft if either journal
is worn below the service limit specification. If worn
past the service limit, replace the balance shaft
assembly.
Balance Shaft Diameter (MAG & PTO)
1.4939 - 1.4946" (37.946 - 37.962 mm)
Service Limit: 1.4921" (37.900 mm)
9925724 R01 - 2014-2015 RZR XP 1000 / RZR XP4 1000 Service Manual

Crankshaft Removal / Inspection

1. Perform Crankcase Disassembly / Inspection, page
2. Perform Balance Shaft Removal / Inspection, page
3. For ease of assembly, mark each connecting rod and
4. Loosen, remove and discard the four connecting rod
5. Carefully lift the crankshaft
© Copyright 2014 Polaris Industries Inc.
ENGINE / COOLING SYSTEM
3.48 procedure.
3.50 procedure.
end cap.
bolts . Remove the end caps from the crankshaft.
1
3
out of the crankcase.
3.51