Outer CV Joint / Boot Replacement
1. Use a side cutters to cut and discard the boot clamps
2. Remove the large end of the boot from the CV joint
and slide the boot down the shaft.
3. Clean the grease from the face of the joint.
9925724 R01 - 2014-2015 RZR XP 1000 / RZR XP4 1000 Service Manual
4. Place the drive shaft in a soft-jawed vise. Using a
5. Make sure circlip
© Copyright 2014 Polaris Industries Inc.
soft-faced hammer, or brass drift, strike the inner
race of the joint to drive the joint off the drive shaft.
Be sure to tap evenly around the joint to avoid
IMPORTANT: Tap on inner race only!
is on the shaft and not left in the