Table of Contents
Advertisement
ELECTRICAL
4. Refer to "Instrument Cluster Trouble Code
Display"page 4.35 trouble code reference table for
a description of each code.
5. If more than one code exists, press the MODE button
to advance to the next trouble code.
6. To exit the diagnostic mode, press and hold the
MODE button or turn the ignition key OFF once the
codes are recorded.
NOTICE
If there is a diagnostic problem with the power steering
system, the power steering MIL will illuminate and blink
in place of the check engine MIL.
INSTRUMENT CLUSTER PINOUTS
FUNCTION
CAN High
CAN Low
Switched Power (Vdc)
Constant Power (Vdc)
Ground
High Beam Input
Fuel Level Sensor
11.18
INSTRUMENT CLUSTER REMOVAL
Do not allow alcohol or petroleum products to come in
contact with the instrument cluster lens.
1. Remove the push rivets
from the vehicle.
2. Disconnect the wire harness connector from the
back side of the instrument cluster.
PIN
1
2
3
4
3. Push the instrument cluster out of the lower dash
panel, while securely holding the panel and rubber
5
mount.
8
11
The instrument cluster bezel is a snap-on assembly and
9929399 R01 - 2018-2019 RANGER XP/ CREW 900/1000 Service Manual
IMPORTANT
q
and upper dash panel
NOTICE
is a serviceable part.
© Copyright Polaris Industries Inc.
Advertisement
Chapters
Table of Contents
Troubleshooting
