Starter One-Way Clutch Assembly - Polaris RZR XP 1000 Service Manual

Starter One-Way Clutch Assembly

1. Install one-way clutch in clutch hub with flange of
clutch engaged in recess.
1
2. Clean screw threads in flywheel to remove all oil or
grease.
3. Place one-way clutch on flywheel and install the
three screws. Torque screws to specification.
One-Way Clutch Retaining Screws:
9 ft-lb (12 Nm)
9925724 R01 - 2014-2015 RZR XP 1000 / RZR XP4 1000 Service Manual
4. Reassemble starter one-way clutch and gear using
5. If starter gear was replaced, inspect the torque limit
6. After assembly, be sure the starter gear rotates in the
© Copyright 2014 Polaris Industries Inc.
ENGINE / COOLING SYSTEM
the following illustration.
Torque Limit Gear
1
Pin
Starter Gear
One Way Clutch
Asm.
Bolt 133 ft-lbs (180
Nm)
gear.
clockwise direction only.
Flywheel
Screws 9 ft-lb (12
Nm)
Torque Limit Gear
Asm.
3.75
3