Neighbor Subnet - Dell Z9500 Command Reference Manual

Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
7.4.1.0
Usage
This command enables soft-reconfiguration for the BGP neighbor specified. BGP
Information
stores all the updates the neighbor receives but does not reset the peer-session.
Related show ip bgp neighbors
Commands

neighbor subnet

Enable passive peering so that the members of the peer group are dynamic.
Z9500
Syntax
neighbor peer-group-name subnet subnet-number mask
To remove passive peering, use the no neighbor peer-group-name subnet
subnet-number mask command.
Parameters
subnet-number
mask
Defaults Not configured.
Command ROUTER BGP
Modes
434
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced.
CAUTION: Inbound update storage is a memory-intensive operation. The
entire BGP update database from the neighbor is stored in memory
regardless of the inbound policy results applied on the neighbor.
NOTE: This command is supported in BGP Router Configuration mode for
IPv4 Unicast address only.
— displays routes received by a neighbor.
Enter a subnet number in dotted decimal format (A.B.C.D.) as
the allowable range of addresses included in the Peer group.
To allow all addresses, enter 0.0.0.0/0.
Enter a prefix mask in / prefix-length format (/x).
Border Gateway Protocol