Avaya S8700 Maintenance Manual page 2355

For multi-connect configurations
Hide thumbs Also See for S8700:
Table of Contents

Advertisement

TIE-DS1 (DS1 Tie Trunk)
Table 8-634. Test #36 Audit and Update Test — Continued
Error
Test
Code
Result
Description / Recommendation
1000
ABORT
System resources required to run this test were not available. The port may be
busy with a valid call.
1. Use the display port UUCSSpp command to determine the trunk
2. If the port status is active but the port is idle (no calls), check the error log
3. If the port status is idle, retry the command at 1-minute intervals up to 5
1006
ABORT
The test was aborted because the trunk is out of service.
1. Use the status trunk command to verify that the trunk is out of service.
2. If the trunk is out of service, determine why.
3. If it is OK to put the trunk back in service, issue the release trunk
2000
ABORT
Response to the test request was not received within the allowable time period.
2100
ABORT
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL
Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
PASS
Trunk translation has been updated successfully. The current trunk states kept
in the DS1 Interface circuit pack and switch software are consistent. If the
trunk is busied out, the test does not run but returns a PASS. To verify that the
trunk is in-service:
1. Enter the status trunk command to verify that the trunk is in-service. If the
2. Enter the release trunk command to put the trunk back into in-service.
3. Retry the test command.
555-233-143
group/member number of the port. Use the status trunk command to
determine the service state of the port. If the service state indicates that
the port is in use, then the port is unavailable for certain tests. You must
wait until the port is idle before retesting.
for error type 1025 (see the error log table for a description of this error and
required actions). The port may be locked up.
times.
command to restore the trunk's service, and then retry the test.
trunk is in-service, no further action is necessary. If the trunk is
out-of-service, continue to step 2.
Continued on next page
Issue 1 May 2002
8-1633

Advertisement

Table of Contents
loading

Table of Contents