Avaya S8700 Maintenance Manual page 2352

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

Maintenance-Object Repair Procedures

Table 8-633. Test #7 Conference Circuit Test — Continued

Description / Recommendation

The port was seized by a user for a valid call.

1. Use the display port UUCSSpp command to determine the trunk

2. If the port status is idle, retry the command at 1-minute intervals up to 5

Test disabled via administration. This only applies to analog stations.

1. To enable test, set the Test field on the station administration screen for the

The test did not run due to a previously existing error on the specific port or

because of a more general circuit pack error.

1. Examine the Error Log for existing errors against this port or circuit pack,

Response to the test request was not received within the allowable time period.

System resources required to run this test are not available.

1. Retry the command at 1-minute intervals up to 5 times.

At least one of the following errors is found on the DS1 circuit pack: 1281 –

Loss of signal,1793 – Blue alarm, 2049 – Red alarm, 2305 – Yellow alarm, or

1537 – Hyperactivity.

Look for the previous error types in the Hardware Error Log, and follow the

procedures given in the appropriate DS1-BD or UDS1-BD maintenance

documentation for the listed error types.

Issue 1 May 2002

group/member number of the port. Use the status trunk command to

determine the service state of the port. If the service state indicates that

the port is in use, then the port is unavailable for certain tests. You must

wait until the port is idle before retesting.

particular analog station being tested to "y." Use the change station

extension command.

and attempt to diagnose the previously existing error.

Continued on next page

Troubleshooting