Avaya S8700 Maintenance Manual page 2417

TSC-ADM (Administered Temporary Signaling
Connections)
Table 8-658. Test #604 TSC Heartbeat Inquiry Test — Continued
Error Test
Code Result Description / Recommendation
1145 ABORT There is congestion in the network.
1. Issue the status tsc-administered command at 1-minute intervals up to 5
2. If the congestion does not clear, disable and enable the Administered TSC
3. If the congestion still does not clear, check other nodes in the network.
1146 ABORT The congestion just occurred in the network.
1. Issue the status tsc-administered command at 1-minute intervals up to 3
2. If congestion does not clear, disable and enable the Administered TSC via
3. If congestion still does not clear, check the other nodes in the network.
1147 ABORT The ADM TSC is being torn down.
1. Issue the status tsc-administered command at 1-minute intervals up to 3
2. If ADM TSC is still down, disable and enable the ADM TSC via the change
3. If the ADM TSC is still down, check the other nodes in the network.
555-233-143
times.
via the change sig-group group command.
NOTE: To disable the Administered TSC, display the (administration)
Signaling Group Form via the change sig-group group command where
<group> refers to the number of the signaling group under which the
suspect TSC is administered. Change the Enable field to "n." To enable
the ADM TSC, change the "Enable" field to "y."
times.
the change sig-group group command.
NOTE: To disable the Administered TSC, display the (administration)
Signaling Group Form via the change sig-group group command where
<group> refers to the number of the signaling group under which the
suspect TSC is administered. Change the Enable field to "n." To enable
the ADM TSC, change the "Enable" field to "y."
times.
sig-group group command.
NOTE:
To disable the ADM TSC, display the (administration) Signaling Group
Form via the change sig-group group command where <group> refers
to the number of the signaling group under which the suspect TSC is
administered. Change the Enable field to "n." To enable the ADM TSC,
change the "Enable" field to "y."
Continued on next page
Issue 1 May 2002 8-1695