Avaya S8700 Maintenance Manual page 2407

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

TONE-PT (Tone Generator)

System Technician-Demanded Tests:

Descriptions and Error Codes

Always investigate tests in the order presented in the table below when inspecting

errors in the system. By clearing error codes associated with the SAKI Reset test

for example, you may also clear errors generated from other tests in the testing

Order of Investigation

SAKI Reset test (#53) (a)

Clock Health test (#46) (b)

Control Channel Loop-around test

Tone Generator Crosstalk test (#90)

Tone Generator Transmission test

Tone Generator Audit/Update test

TDM bus Clock Circuit Status Inquiry

test (#148) (c)

TDM Bus Clock Slip Inquiry test (#149)

TDM bus Clock PPM Inquiry test

TDM bus Clock Parameter Update test

Board Type Check test (#574) (c)

Standby Reference Health Check test

(#651) (c, d)

D = Destructive; ND = Nondestructive

''XXX-BD (Common Port Circuit Pack)''

''TONE-BD (Tone-Clock Circuit)''

''TDM-CLK (TDM Bus Clock)''

d. This test only runs on the standby IPSI or Tone-Clock circuit in an EPN

with more than one IPSI or Tone-Clock circuit pack (high- or

critical-reliability system). The circuit pack must be a TN780 code with

firmware revision 2 or above.

e. Test #149 does not run on the TN2182 or TN2312.

for descriptions of these tests.

Issue 1 May 2002

Troubleshooting