Avaya S8700 Maintenance Manual page 2418

Maintenance-Object Repair Procedures
Table 8-658. Test #604 TSC Heartbeat Inquiry Test — Continued
Error Test
Code Result Description / Recommendation
1148 ABORT The ADM TSC is enabled, but inactive (near end).
1. Disable and enable the ADM TSC.
2. Reissue the test tsc-administered command.
3. If the ADM TSC is still inactive, check the other nodes in the network.
1149 ABORT The ADM TSC is disabled.
1. Enable the TSC, and see if the status indicates "active."
2. Reissue the test tsc-administered command.
3. If the TSC still disabled, remove the ADM TSC from the system.
1181 ABORT Ran out of ADM TSC resources.
1. Reissue the test tsc-administered command at 1-minute intervals up to 3
1182 ABORT The BX.25 link is down at the gateway.
1. Disable the ADM TSC.
2. Check the status of the gateway link via the status link link-num
3. Once the gateway link indicates an "in-service" state, enable the
4. Reissue the test tsc-administered command.
2000 ABORT The Administered TSC is not responding to a TSC heartbeat inquiry.
1. Retry the test tsc-administered command at 1-minute intervals up to 3
2. If the problem continues to fail, obtain the status of the D channel or
3. Reissue the test tsc-administered command.
4. If the test fails, check the ADM TSC node on the other side of the network
8-1696 Issue 1 May 2002
times.
command.
Administered TSC.
times.
D-channel pair associated with the ADM TSC via the status sig-group
group command. If the D channel is INS (i.e., in-service) and the status of
the ADM TSC appears to be active, then disable and enable the ADM TSC
through administration.
NOTE:
To disable the ADM TSC, display the (administration) Signaling Group
Form via the change sig-group group command where <group> refers
to the number of the signaling group under which the suspect TSC is
administered. Change the "Enable" field to "n." To enable the ADM TSC,
change the "Enable" field to "y."
to verify that the ADM TSC is indeed active.
Continued on next page
555-233-143