Ip Address; Show Ip Interface Output Details - Enterasys SECURESTACK C3 Configuration Manual

Stackable switches
Hide thumbs Also See for SECURESTACK C3:
Table of Contents

Advertisement

Table 19-1 show ip interface Output Details
Output Field
Vlan N
Primary IP Address
Frame Type
MAC-Address
Incoming Access
List
Outgoing Access
List
MTU
ARP Timeout
Direct Broadcast
Proxy Arp

ip address

Use this command to set, remove, or disable a primary or secondary IP address for an interface. 
The no form of this command removes the specified IP address and disables the interface for IP 
processing.
Syntax
ip address ip-address ip-mask [secondary]
no ip address ip-address ip-mask
Parameters
ip‐address
ip‐mask
secondary
Defaults
If secondary is not specified, the configured address will be the primary address for the interface.
Mode
Router interface configuration: C3(su)‐>router(Config‐if(Vlan 1))# 
Usage
Each SecureStack C3 system supports up to 24 routing interfaces, with up to 8 secondary 
addresses allowed for each primary IP address. 
What It Displays...
Whether the interface is administratively and operationally up or down.
Inteface's primary IP address and mask. Set using the ip address command as
described in
"ip
address" on page 19-5.
Encapsulation type used by this interface. Set using the arp command as described
in "arp" on page 19-13.
MAC address mapped to this interface.
Whether or not an access control list (ACL) has been configured for ingress on this
interface using the commands described in
page 26-79.
Not supported.
Interface's Maximum Transmission Unit size.
Duration for entries to stay in the ARP table before expiring. Set using the arp
timeout command as described in
Whether or not IP directed broadcast is enabled. Set using the ip directed-broadcast
command described in
"ip
Whether or not proxy ARP is enabled or disabled for this interface. Set using the ip
proxy arp command as described in
Specifies the IP address of the interface to be added or removed. 
Specifies the mask for the associated IP subnet.
(Optional) Specifies that the configured IP address is a secondary address. 
"Configuring Access
"arp
timeout" on page 19-15.
directed-broadcast" on page 19-16.
"ip
proxy-arp" on page 19-14.
SecureStack C3 Configuration Guide 19-5
ip address
Lists" on

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents