Commands; Show Inlinepower - Enterasys SECURESTACK C3 Configuration Manual

The commands in this section apply only to PoE-equipped devices. Consult the Installation Guide for your
product to determine if it is PoE-equipped.
The commands in this chapter allow you to review and set system power and PoE (Power over
Ethernet) parameters, including the power available to the system, the usage threshold for each
module, whether or not SNMP trap messages will be sent when power status changes, and per‐
port PoE settings.

Commands

For information about...

show inlinepower

set inlinepower threshold
set inlinepower trap
set inlinepower detectionmode
show port inlinepower
set port inlinepower
show inlinepower
Use this command to display system power properties.
Syntax
show inlinepower
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Configuring System Power and PoE
Important Notice
Refer to page...
5-1
5-2
5-3
5-3
5-4
5-5
SecureStack C3 Configuration Guide 5-1
5