Show Ipv6 Ospf Interface Stats - Enterasys SECURESTACK C3 Configuration Manual

show ipv6 ospf interface stats

Table 25-7 show ipv6 ospf interface Command Output Details (Continued)
Output Field
Metric Cost
OSPF MTU-ignore
OSPF Interface Type
State
Designated Router
Backup Designated Router
Number of Link Events
show ipv6 ospf interface stats
This command displays statistics for a specific interface. Statistics are displayed only if OSPFv3 is
enabled.
Syntax
show ipv6 ospf interface stats vlan vlanid
Parameters
vlan vlanid
Defaults
None.
Mode
Router privileged execution: C3(su)‐>router#
Example
This example shows how to display statistics for VLAN 80.
C3(su)->router>show ipv6 ospf interface stats vlan 80
OSPFv3 Area ID
Spf Runs
Area Border Router Count
AS Border Router Count
Area LSA Count
IPv6 Address
OSPF Interface Events
Virtual Events
Neighbor Events
External LSA Count
LSAs Received
Originate New LSAs
Sent Packets
25-40 OSPFv3 Configuration
What It Displays...
The priority of the path. Low costs have a higher priority than high
costs.
Whether to ignore MTU mismatches in database descriptor
packets sent from neighboring routers. The following information
only displays if OSPF is initialized on the interface:
Broadcast LANs, such as Ethernet and IEEE 802.5, take the value
broadcast. Tunnel interfaces take the value point-to-point.
The OSPF Interface States are: down, loopback, waiting, point-to-
point, designated router, and backup designated router.
The router ID representing the designated router.
The router ID representing the backup designated router.
The number of link events.
Specifies the VLAN interface for which to display statistics.
0.0.0.20
7
0
0
5
FE80::211:88FF:FE56:5D8F/128
2
0
0
1
1903
4198
1053