show radius interface
Defaults
None.
Example
This example shows how to reset the RADIUS accounting timeout to 5 seconds.
C3(su)->clear radius accounting timeout
show radius interface
Use this command to display the interface used for the source IP address of the RADIUS
application when generating RADIUS packets.
Syntax
show radius interface
Parameters
None.
Defaults
None.
Mode
Switch mode, read‐only.
Example
This example displays the output of this command. In this case, the IP address assigned to
loopback interface 1 will be used as the source IP address of the RADIUS application.
C3(rw)->show radius interface
loopback 1
set radius interface
Use this command to specify the interface used for the source IP address of the RADIUS
application when generating RADIUS packets.
Syntax
set radius interface {loopback loop-ID | vlan vlan-ID}
Parameters
loopback loop‐ID
vlan vlan‐ID
Defaults
None.
26-12 Authentication and Authorization Configuration
192.168.10.1
Specifies the loopback interface to be used. The value of loop‐ID can
range from 0 to 7.
Specifies the VLAN interface to be used. The value of vlan‐ID can range
from 1 to 4093.