Clear Dhcp Pool Host; Set Dhcp Pool Client-Identifier - Enterasys SECURESTACK C3 Configuration Manual

mask
prefix‐length
Defaults
If a mask or prefix is not specified, the class A, B, or C natural mask will be used.
Mode
Switch command, read‐write.
Example
This example shows how to configure the minimum requirements for a manual binding address
pool. First, the hardware address of the client's hardware platform is configured, followed by
configuration of the address to be assigned to that client manually.
C3(rw)->set dhcp pool manual1 hardware-address 0001.f401.2710
C3(rw)->set dhcp pool manual1 host 15.12.1.99 255.255.248.0

clear dhcp pool host

Use this command to remove the host IP address from a manual binding address pool.
Syntax
clear dhcp pool poolname host
Parameters
poolname
Defaults
None.
Mode
Switch command, read‐write.
Example
This example deletes the host IP address from the address pool named "manual1."
C3(rw)->clear dhcp pool manual1 host

set dhcp pool client-identifier

Use this command to configure the client identifier of the DHCP client and create an address pool
for manual binding. You can use either this command or the set dhcp pool hardware‐address
command to create a manual binding pool, but using both is not recommended.
Syntax
set dhcp pool poolname client-identifier id
(Optional) Specifies the subnet mask in dotted quad notation.
(Optional) Specifies the subnet mask as an integer.
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
clear dhcp pool host
SecureStack C3 Configuration Guide 16-17