Priority; Advertise-Interval - Enterasys SECURESTACK C3 Configuration Manual

priority

Use this command to set a priority value for a VRRP router. The no form of this command clears
the VRRP priority configuration.
Syntax
priority vlan vlan-id vrid priority-value
no priority vlan vlan-id vrid priority-value
Parameters
vlan vlan‐id
vrid
priority‐value
Defaults
None.
Mode
Router configuration: C3(su)‐>router(Config‐router)#
Example
This example shows how set a VRRP priority of 200 on the VLAN 1 interface, VRID 1:
C3(su)->router(Config)#router vrrp
C3(su)->router(Config-router)#priority vlan 1 1 200

advertise-interval

Use this command to set the interval in seconds between VRRP advertisements. The no form of
this command clears the VRRP advertise interval value.
Syntax
advertise-interval vlan vlan-id vrid interval
no advertise-interval vlan vlan-id vrid interval
Specifies the number of the VLAN on which to configure VRRP priority.
This VLAN must be configured for IP routing as described in "Pre‐Routing
Configuration Tasks" on page 18‐1.
Specifies a unique Virtual Router ID (VRID) associated with the routing
interface. Valid values are from 1 to 255.
Specifies the VRRP priority value to associate with the vrid. Valid values are
from 1 to 254, with the highest value setting the highest priority. Priority
value of 255 is reserved for the VRRP router that owns the IP address
associated with the virtual router. Priority 0 is reserved for signaling that the
master has stopped working and the backup router must transition to
master state.
SecureStack C3 Configuration Guide 20-45
priority