Ipv6 Route Distance - Enterasys SECURESTACK C3 Configuration Manual

next‐hop‐addr
pref
Defaults
Default preference or administrative distance is 1.
Mode
Router global configuration: C3(su)‐>router(Config)#
Usage
Use the no form of this command to remove a static route. If you do not specify a next hop address
with the no form, all static routes to the specified destination will be removed.
Example
This command creates a static IPv6 route to network 2001:0DB8:2222:4455::/64 by way of interface
VLAN 6 and gives it a preference of 5.
C3(su)->router(Config)# ipv6 route 2001:0DB8:2222:4455::/64 interface vlan 6
fe80::1234:5678:2dd:1 5

ipv6 route distance

This command configures the default distance, or preference, for static IPv6 routes.
Syntax
ipv6 route distance pref
no ipv6 route distance
Parameters
pref
Defaults
Default preference or administrative distance is 1.
Mode
Router global configuration: C3(su)‐>router(Config)#
Link‐local address of the interface.
(Optional) Specifies the preference value the router uses to compare
this route with routes from other route sources that have the same
destination.
The value of pref can range from1 to 255. The default value is 1, which
gives static routes precedence over any other type of route except
connected routes.
A route with a preference of 255 cannot be used to forward traffic.
A distance value used when no distance is specified when a static
route is configured.
The value can range from 1 to 255. Lower route distance values are
preferred when determining the best route.
ipv6 route distance
SecureStack C3 Configuration Guide 22-5