Ip Igmp Query-Max-Response-Time; Ip Igmp Startup-Query-Interval - Enterasys SECURESTACK C3 Configuration Manual

ip igmp query-max-response-time

ip igmp query-max-response-time
Use this command to set the maximum response time interval advertised in IGMPv2 queries.
no form of this command resets the IGMP maximum response time to the default value of 100
(one tenth of a second).
Syntax
ip igmp query-max-response-time time
no ip igmp query-max-response-time
Parameters
time
Defaults
None.
Mode
Interface configuration: C3(su)‐>router(Config‐if(Vlan 1))#
Example
This example shows how to set the IGMP query maximum response time interval to 200 (2 tenths
of a second) on VLAN 1:
C3(su)->router(Config)#interface vlan 1
C3(su)->router(Config-if(Vlan 1))#ip igmp query-max-response-time 200

ip igmp startup-query-interval

Use this command to set the interval between general IGMP queries sent on startup. The no form
of this command resets the IGMP startup query interval to the default value of 31 seconds.
Syntax
ip igmp startup-query-interval time
no ip igmp startup-query-interval
Parameters
time
Defaults
None.
Mode
Interface configuration: C3(su)‐>router(Config‐if(Vlan 1))#
13-14 IGMP Configuration
Specifies the IGMP maximum response time interval. Valid values are
from 0 to 255 tenths of a second.
second).
Specifies the IGMP startup query interval. Valid values are from 1 to 300
seconds. The default value is 31 seconds.
The default value is 100 (one tenth of a
The